Before you begin, Programming overview, Appendix a: fax programming record 51 – Nortel Networks NORSTAR VOICE MAIL 4.0 FAX P0886629 User Manual
Page 52: Before you begin 51 programming overview 51, Appendix a: fax programming record, Provides a programming record to, Appendix a: fax, Programming record
P0886629 Issue 1.0
FAX Set Up and Operation Guide
Appendix A: FAX Programming Record
Before you begin
•
Make copies of the pages in this chapter you will need for recording more
program settings.
•
When a telephone is used for programming, a Norstar two-line telephone must
be used.
Programming overview
This overview provides a recommended approach to FAX programming. To use
this overview:
•
Start at the top and progress down through the programming options. Determine
which options require your attention.
•
You will be programming Fax Mail on an installed Norstar Voice Mail system.
Refer to the Norstar Voice Mail documentation for information on Norstar
Voice Mail system operation. Refer to the Norstar Voice Mail Programming
Record for specific information about what has already been programmed for
Norstar Voice Mail.
•
Refer to the page number to find where that option is in this Programming
Record. Space is provided for you to write the option or circle an option (if
provided). The defaults are shown in bold text.
•
Instructions for accessing each programmable option are provided in brackets
(“F” means “Feature”).
Note: To record the programming for the Dialing Translation Table, refer to
the Norstar Voice Mail Programming Record.
.
Description of programming
Title
Page
Record a general description of your fax setup
Record dialing translation parameters for your system
Dialing Translation
Parameters
Add Fax Mailboxes
(F983, then press MBOX and follow prompts)
Configure Fax Mailboxes
(F983, then press FAX and follow prompts)
Mailbox
Configuration
page 56
Define Fax System Group Lists
(F983, then press GLIST and follow prompts)