Example #4: (config) monitor session 1 mode – NETGEAR 7000 Series Managed Switch User Manual
Page 151
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2
Port Mirroring
17-3
v1.0, May 2008
port, and what is enabled or disabled on the port.
Example #4: (Config) monitor session 1 mode
To set up port mirroring, specify the monitor session, then the mode.
(Netgear Switch Routing) #show port 0/7
Admin Physical Physical
Link
Link LACP
Intf Type
Mode
Mode
Status Status Trap Mode
1/0/7 Mirror Enable Auto
Down
Enable Enable
(Netgear Switch Routing) #show port 0/8
Admin Physical Physical
Link
Link LACP
Intf Type Mode
Mode
Status
Status
Trap Mode
---- ---- ------ -------- -------- ------ ---- ----
1/0/8
Probe
Enable Auto
Down
Enable Enable
(Netgear Switch Routing)(Config)#monitor?
session Configure port mirroring.
(Netgear Switch Routing)(Config)#monitor session?
<1-1> Session number.
(Netgear Switch Routing)(Config)#monitor session 1?
destination Configure the probe interface.
mode Enable/Disable port mirroring session.
source Configure the source interface.
(Netgear Switch Routing)(Config)#monitor session 1 mode?
(Netgear Switch Routing)(Config)#monitor session 1 mode