NETGEAR 7000 Series Managed Switch - Manual (Page 137)

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2
Port Security 13-3
v1.0, May 2008
CLI Examples
The following are examples of the commands used in the Port Security feature.
Example #1: show port security
Example #2: show port security on a specific interface
Example #3: (Config) port security
(Netgear Switch) #show port-security ?
Press Enter to execute the command.
all Display port-security information for all interfaces.
Enter interface in unit/slot/port format.
dynamic Display dynamically locked MAC addresses.
static Display statically locked MAC addresses.
violation Display the source MAC address of the last packet that
was discarded on a locked port.
(Netgear Switch) #show port-security
Port Security Administration Mode: Enabled
(Netgear Switch) #show port-security 1/0/10
Admin Dynamic Static Violation
Intf Mode Limit Limit Trap Mode
---- -------- ------- ------ ---------
1/0/10 Disabled 600 20 Disabled
(Netgear Switch) (Config) #port-security ?
Press Enter to execute the command.
(Netgear Switch) (Config) #port-security