National Instruments AT E Series - Manual (Page 21)

© National Instruments Corporation 2-1 AT E Series User Manual
2
Installing and Configuring the
Device
This chapter explains how to install and configure the AT E Series device.
Installing the Software
Complete the following steps to install the software before installing the
DAQ device.
1. Install the application development environment (ADE), such as
LabVIEW or Measurement Studio, according to the instructions on
the CD and the release notes.
2. Install NI-DAQ according to the instructions on the CD and the DAQ
Quick Start Guide included with the device.
Note It is important to install NI-DAQ before installing the DAQ device to ensure that the
device is properly detected.
Installing the Hardware
You can install an AT E Series device in any available expansion slot in the
PC. However, to achieve best noise performance, you should leave as much
room as possible between the AT E Series device and other devices and
hardware. The following are general installation instructions, but consult
the PC user manual or technical reference manual for specific instructions
and warnings.
1. Write down the AT E Series device serial number. You need this serial
number when you install and configure the software.
2. Turn off and unplug the computer.
3. Remove the top cover or access port to the I/O channel.
4. Remove the expansion slot cover on the back panel of the computer.
5. Ground yourself using a grounding strap or by holding a grounded
object. Follow the ESD protection precautions described in the
Unpacking section of Chapter 1, Introduction .