National Instruments AT E Series - Manual (Page 130)

Appendix A Specifications for AT-MIO-16XE-10 and AT-AI-16XE-10
© National Instruments Corporation A-25 AT E Series User Manual
Gain error (relative to internal reference)
After calibration .............................. ±30.5 ppm max
Before calibration ........................... ±2,000 ppm max
Voltage Output
Range ..................................................... ±10 V, 0 to 10 V
(software selectable)
Output coupling...................................... DC
Output impedance .................................. 0.1
Ω
Current drive .......................................... ±5 mA
Protection .............................................. Short-circuit to ground
Power-on state........................................ 0 V (±20 mV)
Dynamic Characteristics
Settling time for full-scale step .............. 10 µs to ±1 LSB accuracy
Slew rate................................................. 5 V/µs
Noise ...................................................... 60 µV
rms
, DC to 1 MHz
Stability
Offset temperature coefficient ............... ±50 µV/°C
Gain temperature coefficient.................. ±7.5 ppm/°C
Digital I/O
Number of channels ............................... 8 input/output
Compatibility ......................................... TTL/CMOS
Digital logic levels
Level Min Max
Input low voltage 0 V 0.8 V
Input high voltage 2 V 5 V