Figure 1-9 – National Instruments SCXI-1127 User Manual
Page 29
Chapter 1
Installing and Configuring the SCXI-1127/1128
© National Instruments Corporation
1-19
•
At least one other SCXI module other than the SCXI-1127/1128,
installed in the chassis
Consult the documentation for your SCXI chassis and other SCXI modules
for additional instructions and warnings. Any non-SCXI-1127/1128
modules should already be installed according to their installation
instructions. To set up the SCXI-1127/1128 module to be accessed by a
DAQ device via another SCXI module, follow these steps while referring
to Figure 1-9:
Figure 1-9. Installing the SCXI-1127/1128 with Two DAQ Devices
You should have already installed the SCXI-1127/1128 modules and their
HVAB-backplane adapters (1357/1358) according to the instructions found
earlier in this chapter.
1.
Connect the MIO/DIO cable adapter to the rear of a module that is not
the SCXI-1127/1128 module. Secure the adapter to the SCXI chassis
using the screws provided.
2.
Attach your DAQ cable to the cable adapter at the rear connector.
1
Non-SCXI-1127/1128 Module
2
MIO or DIO Device
3
AB0+
4
AB0–
5
NI 4060 for PCI
6
AB2+
7
AB2–
8
SH9MD-9MD Cable
9
HV8-BAN4 Cable
10 2-Slot HVAB-Backplane Adapter
11 SCXI Chassis
12 Digital Signals Connector
13 SCXI-1127/1128 Module
14 HVAB Connector
1
14
11
12
13
2
9
8
10
7
6
5
4
3