Nortel Networks M7410 - Manual (Page 56)

Forwarding your calls 55
P0908510 Issue 02 Enterprise Edge Feature Programming Telephone Guide
If you use ALL to redirect all your lines, it is important that you wait until all the lines
on your telephone light up before pressing
˙
or OK. If you press
˙
or
OK before all the lines light up, those lines not lit are not redirected.
Canceling Line Redirection
ƒ£°›
1. Press ƒ£°› .
2. Select the lines you no longer want to be redirected.
Allowing a telephone to redirect calls
You can turn a telephone’s ability to redirect calls on and off.
You need to start a Unified Manager session to program this feature. For more
information about programming using the Unified Manager, see the Enterprise
Edge Programming Operations Guide.
Turning the redirect ring for a telephone on or off
You can program a telephone to ring briefly (200 milliseconds) when a call is
redirected on one of its lines.
You need to start a Unified Manager session to program this feature. For more
information about programming using the Unified Manager, see the Enterprise
Edge Programming Operations Guide.
Tip
The line chosen for redirecting calls on other lines can be used normally when
it is not busy on a redirected call. To avoid redirection failing because the
chosen line is in use, choose a line pool with several lines in it.
The system does not check that the number you give for line redirection is a
valid one. If you redirect to an invalid number, redirection fails. Using an
autodial button to enter the redirection number helps avoid this possibility. An
autodial button used for line redirection must be programmed to use a specific
line.
Tip
If a telephone has redirect ring enabled, it rings briefly for redirected calls on
one of its lines even if another telephone set up the line redirection.