Control telephone, Using set lock, Changing set lock programming for a telephone – Nortel Networks M7410 User Manual
Page 101: Control telephone 100

100 Using System features
Enterprise Edge Feature Programming Telephone Guide
P0908510 Issue 02
You need to start a Unified Manager session to program this feature. For more
information about programming using the Unified Manager, see the Enterprise
Edge Programming Operations Guide.
Internal assigns an internal number. External assigns an external number. If you
select an external number, you can select the line on which the call is made: the
prime line, an external line, a line in a line pool, or a line selected by the routing
table. If you select a line pool, you must specify the line pool access code. If you
select the routing table, the number dialed is treated as a destination code and is
routed according to the routing tables.
A telephone’s prime line, line pool access codes, and access to a line pool can be
programmed by your installer.
Control telephone
The control telephone allows you to place the telephones and external lines for
which it has responsibility into and out of service schedules. See
Using Set lock
Set lock limits the ways in which you can customize your telephone. There are three
levels of Set Lock: Full, Partial, and None. None allows you to access all features
on your telephone.
Partial prevents:
Full, in addition to the restrictions outlined for Partial lock, prevents:
Changing Set Lock programming for a telephone
You need to start a Unified Manager session to program this feature. For more
information about programming using the Unified Manager, see the Enterprise
Edge Programming Operations Guide.
•
programming autodial buttons
•
programming user speed dial
numbers
•
programming feature buttons
•
moving line buttons
•
changing the display language
•
changing dialing modes
(Automatic Dial, Pre-Dial, and
Standard Dial)
•
using Voice Call Deny
•
saving a number with Saved
Number Redial
•
changing Background Music
•
changing Privacy
•
changing Do Not Disturb
•
using Ring Again
•
using Call Forward all calls
•
using Send Message
•
using Trunk Answer
•
activating Services