Scxi-1343 installation, E-18 – National Instruments SCXI-1163 User Manual
Page 90
SCXI-1163 Cabling
Appendix E
SCXI-1163 User Manual
E-18
© National Instruments Corporation
Table E-6. SCXI-1343 Pin Connections (Continued)
Rear Signal
Connector Pin
SCXI-1163 Use
Connection
Serial
Parallel
20
No Connect
Solder pad
21
No Connect
In (13)
Solder pad
22
No Connect
Solder pad
23
No Connect
In (12)
Solder pad
24
DIG GND (MIO)
Solder pad
25
No Connect
In (11)
Solder pad
26
SERDATOUT (MIO)
Solder pad
27
DAQD*/A
In (10)
Solder pad
28
No Connect
Solder pad
29
SLOT0SEL*
In (9)
Solder pad
30
No Connect
Solder pad
31
SERCLK (DIO)
In (8)
Solder pad
32
No Connect
Solder pad
33
No Connect
In (7)
Solder pad
34
No Connect
In (31)
Solder pad
35
No Connect
In (6)
Solder pad
36
No Connect
In (30)
Solder pad
37
SERCLK (MIO)
In (5)
Solder pad
38
No Connect
In (29)
Solder pad
39
No Connect
In (4)
Solder pad
40
No Connect
In (28)
Solder pad
41
No Connect
In (3)
Solder pad
42
No Connect
In (27)
Solder pad
43
No Connect
In (2)
Solder pad
44
No Connect
In (26)
Solder pad
45
No Connect
In (1)
Solder pad
46
No Connect
In (25)
Solder pad
47
SERDATOUT (DIO)
In (0)
Solder pad
48
No Connect
In (24)
Solder pad
49
No Connect
Solder pad
50
DIG GND (DIO)
DIG GND
Solder pad
SCXI-1343 Installation
1. Insert each wire through the adapter strain relief.
2. Make all solder connections first.
3. Tighten the strain relief screws to secure the wires.
4. Plug the adapter board front connector into the module rear signal connector. A corner of the
adapter board will enter the upper board guide of the chassis.
5. Screw the rear panel to the threaded strips in the rear of the chassis.