National Instruments SCXI-1163 - Manual (Page 89)

Appendix E SCXI-1163 Cabling
© National Instruments Corporation E-17 SCXI-1163 User Manual
4. Connect another ribbon cable to the chassis extender connector in the middle of the
SCXI-1350.
5. Plug the SCXI-1350 into the back of the SCXI module in the first chassis so that the module
rear connector mates with the front connector on the SCXI-1350. When you are connecting
to an SCXI-1163, be sure to set the jumpers for either a DIO-type or an MIO-type board as
appropriate.
6. Screw the rear panel to the threaded strips in the rear of the chassis.
7. Connect the loose end of the ribbon cable from Step 4 into the rear connector of the second
SCXI-1350 and install the adapter board.
8. Continue until all chassis are connected. You do not need to connect anything to the middle
connector of the SCXI-1350 adapter board in the last chassis.
SCXI-1343 Rear Screw Terminal Adapter
You use the SCXI-1343 universal adapter to adapt custom wiring to the SCXI-1163. The
SCXI-1343 has screw terminals and solder pads for signal connection. A strain relief is on the
outside of the rear panel. Table E-6 shows the SCXI-1343 pin connections.
Table E-6. SCXI-1343 Pin Connections
Rear Signal
Connector Pin
SCXI-1163 Use Connection
Serial Parallel
1 No Connect In (23) Solder pad
2 No Connect Screw terminal
3 No Connect In (22) Screw terminal
4 No Connect Screw terminal
5 No Connect In (21) Screw terminal
6 No Connect Screw terminal
7 No Connect In (20) Screw terminal
8 No Connect Screw terminal
9 No Connect In (19) Screw terminal
10 No Connect Screw terminal
11 No Connect In (18) Screw terminal
12 No Connect Screw terminal
13 No Connect In (17) Screw terminal
14 No Connect Screw terminal
15 No Connect In (16) Screw terminal
16 No Connect Screw terminal
17 No Connect In (15) Screw terminal
18 No Connect Screw terminal
19 No Connect In (14) Screw terminal
(continues)