Polycom VVXTM 1500 - Manual (Page 13)

Getting Started with Your Phone
1 - 5
Attaching Ferrite Clamps
Your phone package includes two ferrite clamps. You must attach a ferrite
clamp to the network cable and to the computer cable (if you are connecting a
computer to your phone) before you attach the cables to your phone.
To attach a ferrite clamp to the network cable or PC cable:
>> Clamp a ferrite clamp around the cable.
Connecting Network and Power Sources
There are two ways to connect your phone to the network and a power source.
Your system administrator will advise you which method to use. (If your
phone is already connected to the network and a power source, go directly to
Connecting the Handset and Handset Cord on page 1-8 .)
You can use one of the following methods:
• Connecting the Phone Using a Power Over Ethernet Source
• Connecting the Phone Using AC Power
Note Before you connect the network cable to your phone, make sure you attach a ferrite
clamp to the cable (see
Attaching Ferrite Clamps , above).