Polycom VVXTM 1500 - Manual (Page 11)

Getting Started with Your Phone
1 - 3
Setting Up Your Phone
To set up the phone, do the following:
1. Adjust the stand. See Adjusting the Stand , below.
2. Connect the ferrite clamps to the network cable (and to the optional
computer cable, if you are connecting a computer to your phone). See
Attaching Ferrite Clamps on page 1-5 .
3. Connect the phone to the network and a power source. See Connecting
Network and Power Sources on page 1-5 .
4. Connect phone components. See Connecting the Handset and Handset
Cord on page 1-8 and Connecting Optional Components on page 1-8 .
5. Adjust the screen and camera. See Adjusting the Screen on page 1-12 and
Adjusting the Camera on page 1-13 .
Adjusting the Stand
Your phone is shipped with the stand positioned flat against the phone. To use
the phone, adjust the stand so that the phone is in a more upright position.
You can adjust the stand to one of five positions. The lowest position is labeled
MIN, and the highest position is labelled MAX.
The following figure shows the MIN and MAX labels for the stand.