Panasonic AJ-HD150FE - Manual (Page 113)

– 113 –
(2) Commands relating to inquiries
• As for the return (completion) message, [ACK] is first returned when data is received, and the execution message is
subsequently returned. It is only the execution message which is listed in this table.
• In the case of commands not listed in the table, ER001 (invalid command) is returned after [ACK] has been returned.
VTR
operation
Send command
Return (completion)
message
Supplementary notes
[STX] QCD [ETX] CTL/TC
DATA
REQUEST [STX] CD data [ETX] This command is for inquiring about the counter
value.
[STX] QOP [ETX] STATUS
REQUEST [STX] xxx [ETX]
data =
data = AJ-HD150
f w gh mm ss ff
f
w
gh
mm
ss
ff
= F
= S
=
CTL:
TC:
=
=
=
=
g =
h =
gh =
SP (20h):
– (2Dh):
0–9: hours
00–23: hours
00–59: minutes
00–59: seconds
00–29: frames (525 mode)
00–24: frames (625 mode)
for a plus display
for a minus display
CTL or TC is returned,
whichever corresponds
to the front display
mode.
This command is for inquiring about the VTR’s ope-
ration mode.
xxx = OEJ:
OFF:
OPL:
ORC:
ORW:
OSP:
SRS:
OBF:
OSF:
OSR:
OJG:
OSW:
EAE:
EON:
EPV:
ERV:
EJECT
FAST FORWARD
PLAY
REC
REWIND
STOP (including the STANDBY ON)
(IN/OUT) PREROLL
STANDBY OFF
SHTL FORWARD
SHTL REVERSE
JOG FORWARD/REVERSE
VAR FORWARD/REVERSE
AUTO EDIT
EDIT ON (MANUAL EDIT)
PREVIEW
REVIEW
[STX] QID [ETX]
ID (VTR No.)
REQUEST
[STX] data [ETX] This command is for inquiring about the VTR used.
RS-232C interface