Polycom SpectraLink 6100 MCU - Manual (Page 50)

SpectraLink 6100 MCU: Installation and Operation: SpectraLink 6000 System
PN: 1725-36097-001_G.doc 50
6. If the replacement MCU has STATUS LED 3 and 4 lit, the
configuration data has not been successfully shared. Most likely,
the replacement MCU was powered up before it was correctly
attached to the IPC chain. Repeat the entire replacement
procedure.
Replace a Base Station
To replace a Base Station, unplug the existing Base Station and plug in
the new Base Station.
• The LED will blink red and green as the system software
downloads to the Base Station and the Base Station is tested.
• When the LED blinks amber, the system is ready for operation.
• When the LED blinks green, a handset has established a radio link
with that Base Station.
• If the LED turns solid red, there should be an error message on the
MCU’s
STATUS LEDs and the MCU ERROR LED should be lit.