Polycom SpectraLink 6100 MCU - Manual (Page 39)

Connect and Register Handsets
— Initially Line 2 will flash. This is because Line 1 is usually set up
as the remote access diagnostic modem. To register a handset
to
Line 1 , press the STEP button until Line 1 flashes.
— If the desired line already has a handset registered to it, follow
the procedure outlined below to unregister the handset, then
return to this step.
4. Turn on the handset to be registered by holding down the PWR
key until the handset beeps twice. After a few seconds, the line
indicator LED on the MCU will shine solid red. Once the handset
is registered, the LED for the next line begins to flash.
5. To assign the extension number, hold down the FCN key until
Volume Level displays. Press the # > key until EXTENSION displays
on the handset. Press 0 , then enter the correct extension number.
Press END when finished.
6. Repeat steps 3 through 5 for all handsets to be registered.
7. When all handsets are registered, return the mode switch to the
NORMAL position.
Unregister Handsets
If the desired line already has a handset registered to it, follow this
procedure to unregister the handset.
1. Move the mode switch on the MCU to the
REGISTER position. If
your system has more than one MCU, be sure to move the switch
on the correct MCU. The
LINE indicator LEDs now show which
lines have handsets registered.
2. Use the STEP button to select the line to be unregistered. The LINE
indicator LED for a line that has a handset registered to it will
flash with the LED mainly on.
3. Press the DEL/ENTER button. The LINE indicator LED for the selected
line will be off with a short on flash
4. Register the new handset or return the mode switch to the
NORMAL position.
PN: 1725-36097-001_G.doc 39