Polycom SpectraLink 6100 MCU - Manual (Page 48)

SpectraLink 6100 MCU: Installation and Operation: SpectraLink 6000 System
Replace a Handset
If a handset breaks or needs to be replaced, the old handset must be
deleted and the new handset added.
Delete old handset
1. Make sure all unregistered handsets are off. If this is not done an
unregistered handset may unintentionally register to an available
line.
2. Move the mode switch to the REGISTER position on the MCU.
3. Press the STEP button until the LED for the line to be deleted is
flashing red.
4. Press the DEL/ENTER button.
You can now register a new handset or return the mode switch to the
NORMAL position.
Register new handset
1. Make sure all unregistered handsets are off.
2. Move the mode switch to the
REGISTER position.
3. Press the STEP button until the desired line to be registered is
flashing red. Only unregistered lines can be registered.
4. Press PWR on the handset that needs to be registered. The LED
should change to mostly on once the handset is registered.
5. Wait at least three seconds and then press END .
6. Return the mode switch to the NORMAL position.
7. To assign the extension number, hold down the FCN key until
Volume Level displays. Press the # > key until EXTENSION displays
on the handset. Press 0 , then enter the correct extension number.
8. When the handset is turned on, the extension will be displayed.
Test the handset by placing a call to each handset to verify that the
correct handset rings.
PN: 1725-36097-001_G.doc 48