Primera Technology BravoPro Optical Disc Printing System - Manual (Page 22)

18 Printing Discs on a PC
Ink Saturation
This option controls the ink saturation of the printed image.
When printing onto the printer manufacturer's TuffCoat CD
media, this option can be left at its default setting of 100%.
When printing onto other brands of printable CD media, you
may need to adjust this control in order to optimize the ink
saturation for the printable surface of your specific CD media.
Click on the up and down arrows to change the ink saturation
setting. Lower numbers reduce the overall ink saturation,
while higher numbers increase it. If discs do not seem to be
drying completely it may be necessary to reduce this value.
Calibration Options
Click on the plus to reveal the following four Calibration
options.
Inner Diameter
This value changes the size of the non-printed center. Larger
numbers cause the non-printed center to be larger and smaller
numbers make the non-printed center smaller. This number is
incremented by 0.1mm so a change of 10 for inner diameter
changes the diameter by 1mm.
Inner Diameter Non-Printed Diameter
386 1.518" (38.6mm) (TuffCoatTM, Default)
220 0.865" (22.0mm) (Typical Hub-Printable CD/DVD)
150 0.591" (15mm) (Physical Center)
Cartridge Alignment
The Cartridge Alignment prints a test print and then
automatically scans the print to configure your printer for
bidirectional printing and to align the color and black
cartridges for Color+Black printing. It is important to perform
this calibration every time you change a cartridge. If you forget
to perform this calibration you will be prompted to do so
before your first print from the new cartridge.
510921PM.qxd 1/26/2005 11:12 AM Page 18
TOC INDEX