Existing, Confirming, Existing windows xp installation – Promise Technology FastTrak TX4000 User Manual
Page 41: Confirming windows xp driver installation
Chapter 4: Installing Software Drivers
37
Existing Windows XP Installation
After installing the FastTrak TX4000 card and rebooting your system, Windows
XP setup will show a “Found New Hardware” dialog box. Under Windows XP,
“Mass Storage Controller” will be displayed.
1.
Insert the FastTrak TX4000 driver diskette into the A:\ drive.
2.
Choose Install the software automatically and press the Enter key.
3.
Choose WinXP Promise FastTrak TX4000 Controller from the list that
appears on screen, and then press the Enter key.
4.
If using a driver that has not been digitally signed by Microsoft, you will be
asked if you want to continue the installation. Click Continue anyway.
5.
When the New Hardware Wizard has finished installing the FastTrak
TX4000 software, click Finish.
6.
Reboot your system.
Confirming Windows XP Driver Installation
1.
From Windows XP, open the Control Panel from the My Computer icon.
2.
Click Performance and maintenance.
3.
Click the System icon.
4.
Click the Hardware tab, then click the Device Manager tab.
5.
Click the “+” in front of SCSI and RAID controllers. WinXP Promise
FastTrak TX4000 Controller should appear.