Promise Technology FastTrak TX4000 - Manual (Page 12)

FastTrak TX4000 User Manual
8
IDE 2
IDE 4 IDE 3
IDE 1
LED Pin 1
Figure 2. TX4000 card
Important
You must use an 80-wire, 40-pin cable when connecting your
hard drives to the FastTrak TX4000 controller card. The
FastTrak TX4000 package contains four 80-wire, 40-pin cables.
Notes
• The FastTrak TX4000 Controller card is a PCI Plug-n-Play
(PnP) device. No changes are necessary in the Motherboard
CMOS Setup for resources or drive types in most
applications.
• If you wish to boot from a FastTrak TX4000 drive array AND
continue to use hard drives attached to your motherboard’s
IDE controller, refer to your motherboard manual for the
specific BIOS settings to use in order to establish their
proper boot order.