Perle Systems S-110P - Manual (Page 3)

Perle PoE/PoE+ 10/100 Ethernet Media Converter
3
PoE (P)
PoE+ (PP) Connector
(xx) Mode
Distance Wavelength
(TX/RX)
S-110P-SFP
S-110PP-SFP
SFP NOTE 1
Extended Temperature Models
PoE (P)
PoE+ (PP) Connector
(xx) Mode
Distance Wavelength
(TX/RX)
S-110P-M2xx2-XT
S-110PP-M2xx2-XT
SC/ST
MM
2 km/1.2 mi.
1310 nm
S-110P-S2xx20-XT
S-110P-S2xx20-XT
SC/ST
SM
20 km/12.4 mi.
1310 nm
S-110P-S1SC20U-XT
S-110PP-S1SC20U-XT
SC
SM
20 km/12.4 mi.
1310/1550 nm
S-110P-S1SC20D-XT
S-110PP-S1SC20D-XT
SC
SM
20 km/12.4 mi.
1550/1310 nm
S-110P-SFP-XT
S-110PP-SFP-XT
SFP NOTE 1
Note 1: Fiber characteristics will depend on the SFP fiber
module selected.
Installation
The default DIP switch settings (all switches in the UP
position) will work for most installations. These are the steps
required to configure the Perle S-110P Ethernet media
converter:
1. Insert SFP Module (SFP Model only).
2. Set the DIP switch settings (if required).
3. Set the Powering Option Jumpers (if required).
4. Install and connect the fiber cable.
5. Install and connect the copper cable.
6. Install the Power cord Relief clip (optional).
7. Power up the media converter.