Perle Systems S-110P - Manual (Page 12)

Perle PoE/PoE+ 10/100 Ethernet Media Converter
12
Duplex Fiber (Switch 3)
Switch Position Copper port
Up (default) Full Duplex
Down Half Duplex
Note: When Auto-negotiation (SW1) is set to Off, the media
converter will use this Duplex setting for the copper port.
Full Duplex: In the Up switch position; the media converter
will be set to Full Duplex mode.
Half Duplex: The media converter will be set to Half Duplex
mode.
Auto/MDIX (Switch 4)
Switch Position Copper port
Up (default) Auto
Down MDIX
Auto: In the Up switch position; the media converter will
automatically detect the Ethernet cable’s polarity.
MDIX: The S-110P will operate as a MDIX device.
Installing the SFP Fiber Module
1. SFP models only.
2. Locate the appropriate fiber module and insert the SFP
into the opening on the front of the media converter.
3. Ensure the SFP module is properly seated. The release
latch of the SPF fiber transceiver must be in the closed
(up) position before insertion.
4. The SFP module may be inserted before or after
applying power to the media converter.
5. Proceed with cable connections.