Perle Systems S-110P - Manual (Page 16)

Perle PoE/PoE+ 10/100 Ethernet Media Converter
16
Operation
Status LED
The Perle PoE/PoE+10/100 Rate converting Media
converters have status LEDs located on the front panel of
the unit.
PWR
On – Power is applied to the unit
Blinking (slow) – Loopback mode - fiber interface is in loopback mode
Blinking (fast) Power On failure. See LED Pattern to determine pattern combination
and failure cause
LED Pattern
LKF LKC 100 PSE
Off Off On On SFP incompatible
All other LED patterns
Internal hardware
failure
LKF- (Status on Fiber Link)
On – Fiber link is present
Off – No fiber link present
Blinking (fast) – Fiber link up and receiving data
100- (Copper Port)
On – 100 Mbps (valid link and detected speed is 100 Mbps)
Off – 10 Mbps (if link is currently established)