Panasonic KX-MB3020 - Manual (Page 69)

9. Programmable Features
69
Approving users for the LAN
connection
{#}{
5}{3}{2}
{ 0} “ DISABLED” (default): Deactivates this feature.
{ 1} “ ENABLED”: The unit will deny/approve access from the pre-programmed
IP patterns. You can program whether to deny or approve IP addresses. Up to
4 patterns each for IPv4 and IPv6 can be programmed through the web browser
interface.
1. Start Multi-Function Station.
2. [Utilities] i [Configuration Web Page] i [Network Configuration]
3. Type “root” as the user name, then enter the password (feature #155 on
page 56). i [OK]
4. Select the [LAN FEATURE] tab.
5. Click [Edit] next to [APPROVED USERS].
6. Click [Edit] next to [FILTER(IPv4)]/[FILTER(IPv6)].
7. Change the mode and edit IP filtering information. i [Submit]
8. Close the web browser.
Setting the IP address
automatically for the LAN
connection
{#}{
5}{3}{3}
This feature will be displayed only when feature #500 is activated.
{
0} “ DISABLED” (default): Deactivates this feature.
{ 1} “ ENABLED”: IP address will be allocated automatically without using a
DHCP (Dynamic Host Configuration Protocol) server.
Setting HTTPD for the LAN
connection
{#}{
5}{3}{4}
{ 0} “ DISABLED”: Denies access to the web browser.
{ 1} “ ENABLED” (default): Allows access to the web browser.
IPv6 protocol
{#}{
5}{3}{5}
{ 0} “ DISABLED” (default): Deactivates this feature.
{ 1} “ ENABLED”: IPv6 protocol can be used. After installing the printer driver, be
sure to change the port to IPv6 protocol. You can check the IPv6 protocol
address by printing the “
SETUP LIST” (page 98).
Note:
L To activate this feature, you need to turn the power switch of the unit OFF,
then ON.
Setting the paper input tray to
use for the scan to email print
feature
{#}{
5}{6}{5}
This feature will be displayed only when the lower input tray is installed (page
74).
{
1} “ #1” (default): Standard input tray
{ 2} “ #2”: Lower input tray
{ 3} “ #1+#2”
Note:
L To select “ #2”, select “PLAIN PAPER” or “THIN PAPER” for the recording
paper type setting (feature #383 on page 57).
L To select “ #1+#2”,
– select the same paper size for the standard input tray (feature #380 on
page 57) and lower input tray (feature #382 on page 57). If either is
changed, “
#1” will be selected automatically.
– select “ PLAIN PAPER” or “THIN PAPER” for the recording paper type
setting (feature #383 on page 57).
Erasing all email addresses
stored in the unit
{#}{
5}{7}{8}
{ 0} “ NO” (default)
{ 1} “ YES”
L Disconnect the telephone line cord (KX-MB3020 only), USB cable and LAN
cable before activating this feature.
To erase all email addresses:
1. {Menu} i {#}{5}{7}{8}
2. Press {1} to select “ YES”. i {Set}
3. Press {1} to select “ YES”. i {Set} i {Menu}
Feature/Code Selection