Paradyne 6218 - Manual (Page 38)

3. Using the Web Interface
3-14 February 2005 6218-A2-GB20-00
The Apply button will temporarily save these settings. To make the change
permanent, click on Tools (at the top of the page) and select System Commands.
At the System Commands page, click on Save All.
Configuring the LAN
To configure LAN parameters, click on Setup on the Home screen. Under LAN
Setup, click on LAN Configuration. The LAN Configuration screen appears.
Enable/Disable DHCP
By default, your CPE has DHCP server (LAN side) disabled. If you already have a
DHCP server running on your network, do not enable a second DHCP server.
To enable DHCP:
Procedure
1. From the Home screen, click on Setup.
2. Under LAN Setup, select LAN Configuration. The LAN Group 1 Configuration
screen appears.
Figure 3-10. LAN Group 1 Configuration