Polycom SpectraLink NetLink 72-1065-09 - Manual (Page 46)

SpectraLink Corporation Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone
NetLink Telephony Gateway and SpectraLink Radio Protocol
PN: 72-1065-09-K.doc Page 46
Message Description Action
System Busy
yyy.yyy.yyy.yyy
y…y = SVP Server/Telephony Gateway IP
Address
Gateway or SVP server has reached call
capacity; displays IP address of
Gateway/SVP Server.
All call paths are in use, try the call again in a
few minutes.
System Locked
(with Busy Tone)
Gateway is locked. Try the call again, system has been locked for
maintenance.
TFTP ERROR(x):yy A failure has occurred during a TFTP
software download. (x) = The file number
which was being downloaded; yy is an
error code describing the particular
failure. Possible error codes are:
01 = TFTP server did not find the
requested file.
02 = Access violation (reported from TFTP
server).
07 = TFTP server reported "No such
user" error.
16 = No TFTP server address
81 = File put into memory did not CRC.
FF = Timeout error. TFTP server did not
respond within a specified period of time.
Error code 01, 02, 07 or 16 - check the TFTP
server configuration.
Error code 81, the handset will attempt to
download the file again.
For other messages, power off the handset,
then turn it on again to retry the download. If
the error repeats, note it and contact
SpectraLink Technical Support.
Too many errors The handset continues to reset and
cannot be recovered.
Fatal error. Return handset to SpectraLink.
Unknown
xx:yy:zz
A phrase is missing from your phintl file. Download new software from the SpectraLink
site per section 8 Software Maintenance .
Updating … The handset is internally updating its
software images
None. The handset may do this briefly after a
download. This is informational only.
Updating Code Handset is downloading new software
into memory. The number icons at the
bottom of the display indicate which file
number is currently being downloaded.
This message also displays a progress
bar. When the progress bar fills the
display line the update operation is
complete on that file.
None. When the progress bar fills the display
line the update operation is complete on that
file.
Do not turn the handset off during this
operation.
Use Deskset Handset is inserted in Docking Station
cradle.
Not an error. Use the Docking Station or
remove handset from cradle.
Wrong Code Type The software loaded into the handset is
the wrong type for this model handset.
Verify the license type is set correctly.
If the license type is correct, replace the
software image on the TFTP server with the
software that is correct for the handset model.
Waiting Handset has attempted some operation
several times and failed, and is now
waiting for a period of time before
attempting that operation again.
None. The handset is waiting for a specified
period of time before attempting that
operation again.