Polycom SpectraLink NetLink 72-1065-09 User Manual
Page 42
SpectraLink Corporation
Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone
NetLink Telephony Gateway and SpectraLink Radio Protocol
PN: 72-1065-09-K.doc
Page 42
Message Description
Action
(battery icon),
Battery Low,
beep (audio)
Low battery.
In call: the battery icon displays and a soft
beep will be heard when the user is on the
handset and the battery charge is low. User
has 15–30 minutes of battery life left.
The Battery Pack can be changed while the
call is still in progress. Do not press Power
Off/End Call. Quickly remove the discharged
battery and replace with a charged battery,
power on the handset and press Power
On/Start Call to resume the call in progress.
Not in call: The battery icon displays whenever
the Battery Pack charge is low The message
Low Battery and a loud beep indicate a
critically low battery charge when user is not
on the handset. The handset will not work until
the Battery Pack is charged.
Battery Failure
The Battery Pack is not functioning.
Replace the Battery Pack with a new or
confirmed SpectraLink Battery pack. Any non-
SpectraLink Battery Packs will not work.
Battery Failed
Battery Pack is damaged or incompatible
with handset.
Replace the Battery Pack with a new or
confirmed SpectraLink Battery pack. Any non-
SpectraLink Battery Packs will not work.
Cant Renew DHCP
yyy.yyy.yyy.yyy
y…y = DHCP server IP address
DHCP server is not responding to initial
renewal attempt.
Configuration problem. Check the IP address
configuration in the DHCP server.
Charging …
The handset is charging in the Desktop
Charger.
No action needed.
Charge Complete
The handset is now fully charged
No action needed.
Checking Code
Handset is contacting the Download
Master to determine if it has a newer
version of software that should be
downloaded.
None, this message should only last for
approximately one second. If message
remains displayed, power off and contact
customer support for a replacement handset.
Checking DHCP IP
The handset is retrieving DHCP
information from the DHCP server.
None. This is informational only.
CRC Code Error
The software which has been TFTP
downloaded has a bad redundancy code
check.
Try the download again, it is possible the
software was corrupted during download. If
the error repeats, check that the download
image on the TFTP server is not corrupted.
Code Mismatch!
The software loaded into the handset is
incorrect for this model handset.
Verify the License Management value is
correct. Replace the software image on the
TFTP server with software that is correct for the
handset model.
DCA Timeout
The handset has detected a fault from
which it cannot recover, possibly due to a
failure to acquire any network.
Turn the handset off then on again. If error
persists, contact SpectraLink Technical
Support and report the error.