Polycom SpectraLink NetLink 72-1065-09 - Manual (Page 29)

SpectraLink Corporation Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone
NetLink Telephony Gateway and SpectraLink Radio Protocol
PN: 72-1065-09-K.doc Page 29
5. Testing a Handset
Verify proper registration and operation of each handset by performing the
following tests on the handset in an active wireless area.
1. Power on the handset by pressing
Power On . You will see a series of messages
displayed as the handset acquires the system. The handset should display the user
extension or dashes if no extension is programmed. Any error messages should
clear.
2. Press the Start Call key. The extension number should clear and you should hear
dial tone. On some digital systems, depending on how the telephone system is
programmed, you may have to select a line to get dial tone. Place a call and listen
to the audio quality. End the call by pressing the End Call key.
3. Place a call to the handset and verify ring, answer, clear transmit, and clear
receive audio.
4. Use the FCN key to verify all softkey programmed features on the handset. Use
the MENU key and scroll through the Shortcut menu. Ensure the features
displayed on the Shortcut menu match those displayed in the softkey function
display area.
5. Press the End Call key. Any line indicators should turn off and the extension
number display will return.
If any of these steps fails to operate as described, refer to section 9 Troubleshooting
for corrective action.