Polycom SpectraLink NetLink 72-1065-09 User Manual

Page 20

SpectraLink Corporation

Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone

NetLink Telephony Gateway and SpectraLink Radio Protocol

PN: 72-1065-09-K.doc

Page 20

WPA-PSK

The security features of WPA (Wi-Fi Protected Access) using PSK (pre-

shared key) are available and may be used if supported by the access points in the

facility. Select either

Passphrase

and enter a passphrase between 8 and 63 characters

in length or

Direct Entry

and enter the 256-bit key code.

WPA2-PSK

The security features of WPA2 using PSK are available and may be used

if supported by the access points in the facility. Select either

Passphrase

and enter a

passphrase between 8 and 63 characters in length or

Direct Entry

and enter the 256-

bit key code.

Consult the Configuration Guide for the access points installed in your
facility for information on which of the WPA versions are recommended
by SpectraLink engineering. Configure the recommended version on the
AP and select the corresponding option on the Admin menu.

Regulatory Domain

The Regulatory Domain will default to North America on the handset display. FCC
requirements dictate that the menu for changing the domain be available by

password, which in our case is the

LINE

key. To change the domain, press

LINE

and

then enter the digits that represent the site’s domain. Note that both digits must be
entered.

- North America

- Europe (except Spain and France); Japan (channels 1-13)

- Spain

- France

As of this writing, Spain and France are adopting the general European
Regulatory rules. Check with your wireless LAN administrator or supplier
for which domain to enter in these countries.

Transmit Power

Default transmit power is Maximum. It may be set to a lower number if necessary. If
changed from the default, ensure the Transmit Power setting is the same on all
handsets and all APs.

Power is limited to 30mW in regulatory domains other than North
America.

Diagnostics
Run Site Survey

The Site Survey mode is activated by selecting this option. Site survey starts running
immediately upon selecting this option. See the Diagnostic Tools section for more
information about Site Survey.

Diagnostics Mode

See section 6.2 Diagnostics Mode for a detailed explanation of the Diagnostics Mode
options.

Syslog Mode

See section 6.3 Syslog Mode for a detailed explanation of the Syslog Mode options.