Panasonic AJ-D650 - Manual (Page 32)

USER menu
(continued)
Item Setting
Description
This sets the channel assignments for the controller’s analog
audio preset when editing the digital audio of the VTR using a
controller which does not have a digital audio edit preset
control function.
This selects the channel concerned when the VTR CUE edit
preset is set in compliance with the ON or OFF presetting for
the analog audio signals designated by the editor or
controller.
0: Not set.
1: Compliance with analog CH1 edit preset.
2: Compliance with analog CH2 edit preset.
3: Compliance with either analog CH1 ot CH2 edit preset.
This selects the connection method for the digital audio edit
IN point.
0: Cut processing
1: V Fade processing
This selects the connection method for the digital audio edit
OUT point.
0: Cut processing
1: V Fade processing
This selects the mode after cue-up operation is complete.
0: STOP mode
1: SHTL STILL mode
Superimposed
display
EDIT
RPLCEC
AUD EDIT
IN
AUD EDIT
OUT
AFTER
CUE-UP
Superimposed
display
N-DEF
CH1
CH2
CH1+2
No.
307*
No.
0000
0001
0002
0003
309* CUT
FADE
CUT
FADE
STOP
STILL
0000
0001
0000
0001
0000
310*
313
0001
The underline on the setting item denotes the initial setting.
* The Setup menu can only be displayed for the model AJ-D650.
USER menu
Item Setting
Description
This selects the time to be taken until the unit goes into the tape
protection mode when it is left standing in the stop mode.
(Unit: s = second, min = minute)
With the DV format, the maximum time which can be set is
10s even when a setting above 10s has been selected. The
selection screen, however, will operate for up to 2 minutes.
Superimposed
display
STILL
TIMER
No.
Superimposed
display
0000 0.5s
0001 5s
0002 10s
0003 20s
0004 30s
0005 40s
0006 50s
0007 1min
0008 2min
No.
400
401 SRC
PROTECT
0000 STEP
HALF
This selects the operation during the tape protection mode
when the unit is left standing in the still status in No. 400
protection mode.
0: STEP FWD.
1: HALF LOADING.
When STEP FWD is selected, the unit automatically goes into
the HALF LOADING mode when the total time for which the
unit is left standing in the still status reaches 30 minutes
(DVCPRO) or 1 minute (DV).
0001
The underline on the setting item denotes the initial setting.
In order to protect the tape and VTR helical heads, it is recommended that the Still Timer be
set for automatic tape protection mode in 30 seconds or under.
– 3 2 –