PC Concepts Full-Rated Router ADSL2+ - Manual (Page 55)

54
[Enabling Bridgeable Interfaces]
To enable bridging, you use the Bridge Configuration page to specify the interfaces that
can bridge data. Then, you use the System Mode page to enable the appropriate operating
mode.
1. If the Bridge Configuration page is not already displaying, click the Bridging tab.
The Bridge Configuration Page displays by default.
The page displays Enable/Disable links for Bridging, WAN-to-WAN Bridging, and Zero
Installation PPP bridge (ZIPB). The page also provides a table for specifying the interfaces on
which bridging will be performed. The table may be empty if bridging has not yet been
configured.
2. Select the interface names on which you want to perform bridging and click Add.
[Enabling Bridging Services]
After configuring the bridgeable interfaces, click one of the following links on the Bridge
Configuration Page:
• Bridging: Enable/Disable
• WAN to WAN Bridging: Enable/Disable
• ZIPB: Enable Disable
Each of the links displays the System Mode Page, where you can enable the appropriate
bridging operating mode.
5.5.2 LAN Configuration
This topic allows user to configure the interfaces on the ADSL/Ethernet router that
communicate with your LAN and USB computers.