Pioneer BDP-320 - Manual (Page 56)

07
56
En
Cautions on use
Moving the player
If you need to move this unit, fi rst remove the disc if
the re’s one loaded, and close the disc tray. Next, press
 STANDBY/ON to switch the power to standby,
checking that the
POWER OFF indication on the front
panel display goes off. Wait at least 10 seconds. Lastly,
disconnect the
power cord.
Neve r lift or move the unit during playback — discs rotate
at a high s peed and may be damaged.
Place of installation
Select a stable place near the TV and AV system to which
the unit is connected.
Do not place the player on top of a TV or color monitor.
Kee p it away from cassette decks or other components
easily affected by magnetism.
Avoid the following ty pes of places:
• Places ex posed to direct sunlight
• Humid o r poorly ventilated places
• Ext remely hot or cold places
• Places subject to vib ration
• Dusty places
• Places ex posed to soot, steam or heat (in kitchens,
etc.)
 Do not place objects on top
Do not place objects on top of the player.
 Do not obstruct the ventilation
holes
Do not use the player on a shaggy rug, bed, or sofa, and
do not cove r the player with a cloth, etc. Doing so will
prevent heat dissipation and could lead to damage.
 Keep away from heat
Do not place the player on top of an amplifier or other
device gene rating heat. When installing in a rack, to avoid
the heat gene rated by the amplifier and other devices,
place it on a shelf below the amplifier whenever possible.
Turn the power off when not
using the player
De pending on the conditions of the TV broadcast signals,
st riped patterns may appear on the screen when the TV is
tu rned on while the player’s power is turned on. This is not
a malfunction with the player or TV. If this happens, turn
the player’s power off. In the same way, noise may be
hea rd in the sound of a radio.
Condensation
If the player is moved suddenly from a cold place into a
wa rm room (in winter, for example) or if the temperature
in the room in which the player is installed rises suddenly
due to a heate r, etc., water droplets (condensation) may
fo rm inside (on operating parts and the lens). When
condensation is present, the player will not operate
properly and playback is not possible. Let the player stand
at
room temperature for 1 or 2 hours with the power
tu rned on (the time depends on the extent of
condensation). The wate r droplets will dissipate and
playback will become possible.
Condensation can also occu r in the summer if the player
is ex posed to the direct wind from an air-conditioner. If
this ha ppens, move the player to a different place.
Cleaning the player
No rmally, wipe the player with a soft cloth. For tough dirt,
a pply some neutral detergent diluted in 5 to 6 parts water
to a soft cloth, w ring out thoroughly, wipe off the dirt, then
wi pe again with a dry cloth.
Note that getting alcohol, thinne r, benzene or insecticide
on the player could cause the print and coating to peel off.
Also, avoid leaving rubber or vinyl products in contact
with the player for long periods of time, as this could
damage the cabinet.
When using chemical-im pregnated wipes, etc., read the
wi pe’s cautions carefully.
Un plug the power cord from the power outlet when
cleaning the player.
Caution for when the unit is
installed in a rack with a glass
door
Do not press the  OPEN/CLOSE on the remote control
to o pen the disc tray while the glass door is closed. The
doo r will hamper the movement of the disc tray, and the
unit could be damaged.
Cleaning the pickup lens
The player’s lens should not become dirty in normal use,
but if fo r some reason it should malfunction due to dust
o r dirt, consult your nearest Pioneer authorized service
cente r. Although lens cleaners for players are
comme rcially available, we advise against using them
since some may damage the lens.
Handling discs
Do not use damaged (c racked or warped) discs.
Do not sc ratch the disc’s signal surface or let it get dirty.
Do not load mo re than one disc into the player at a time.
320_UXJCA_EN.book 56 ページ ２００９年２月１３日 金曜日 午後４時２６分