Pioneer Elite VSX-23TXH - Manual (Page 73)

Controlling the rest of your system 09
73
En
Chapter 9:
Controlling the rest of your system
Operating multiple receivers
The remote control included with this receiver can be
used to operate up to three other receivers (of the same
model as this receiver) in addition to this receiver. The
receiver to be operated is switched by inputting the
preset code to set the remote control setting.
• Set the remote modes on the receivers before using
this function (see Remote Control Mode Setup on
page 96).
1 Check the operation selector switch to MAIN.
2 Press .
3 Press and hold REMOTE SETUP, then release it after
the LED flashes twice.
4 Use the number buttons to enter the 5-digit preset
code (see below).
• Receiver 1: 6 1 9 3 5 (Default)
• Receiver 2: 6 2 6 3 0
• Receiver 3: 6 2 6 3 1
• Receiver 4: 6 2 6 3 2
When the preset code is fully input, the LED flashes once
to indicate that the setting is completed.
To operate another receiver, start over from step 1 to
input its preset code.
Setting the remote to control other
components
Most components can be assigned to one of the input
function buttons (such as DVD or CD) using the
component’s manufacturer preset code stored in the
remote.
However, there are cases where only certain functions
may be controllable after assigning the proper preset
code, or the codes for the manufacturer in the remote
control will not work for the model that you are using.
Note
• You can cancel or exit any of the steps by pressing
. To go back a step, press RETURN.
• After one minute of inactivity, the remote
automatically exits the operation.
Selecting preset codes directly
1 Press the input function button for the component
you want to control. 1
When assigning preset codes to TV CONTROL, press TV
CTRL here.
2 Press and hold REMOTE SETUP, then release it after
the LED flashes twice.
3 Use the number buttons to enter the 5-digit preset
code.
See Preset code list on page 113.
When the preset code is fully input, the LED flashes once
to indicate that the setting is completed.
4 Repeat steps 1 through 3 for the other components
you want to control.
To try out the remote control, switch the component on or
off (into standby) by pressing
 SOURCE. If it doesn’t
seem to work, select the next code from the list (if there
is one).
1 2 3
SLEEP
HDMI OUT
MCACC SIGNAL SEL
4 5 6
DIMMER A.ATT SBch
7 8 9
CLASS CH LEVEL D.ACCESS
0 ENTER
INPUT
SELECT
REMOTE
SETUP
ZONE 2
MAIN
ZONE 3
AUDIO INFO
DISP
CH
RECEIVER TV CTRL
RECEIVER
Note
1 You can’t assign , TUNER, iPod/USB, XM or SIRIUS.
RECEIVER
RECEIVER
VSX-23TXH_CUXJ.book 73 ページ ２００９年５月８日 金曜日 午前１０時４５分