Paxar 9430R User Manual
Page 14
2-6 Creating and Printing Formats
4.
Save the graphic to flash memory using the following command:
ESC-'LG'-FF hex
When it receives the command, the printer returns a ‘D‘ character, and
begins the save. When the save is complete, the printer transmits an
‘!’ character, and then an ‘X’ character every 500 milliseconds.
5 . Remove the printer’s battery and wait several seconds before replacing
it.
6 . Print the flash memory graphic with the following command:
ESC-'Lg0'
All these commands are described in detail in the following table.
Command Summary
Command
Description
ESC-'DL'
Step 1 of entering Download Mode. After
processing this command, the printer returns a
‘?’ character.
ESC-'LG0'
Step 2 of entering Download Mode. Any
character not accepted as part of this
command is sent back to the host.
ESC-'LG'-FF hex
Saves the graphic. After receiving this
command, the printer returns a ‘D’ character,
and then saves the graphic.
When finished, the printer sends an ‘!’
character, then it sends an ‘X’ character every
500 milliseconds.
ESC-'Lg0'
Prints the graphic stored in flash memory.