Paxar 9430R User Manual
Page 13
Creating and Printing Formats 2-5
Example
This line of code prints a solid horizontal line of dots.
ESC-V-1-0-
FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF
FFFF
ESC-'a'-
Specifies the amount the space for the printer
to leave between lines.
.125 mm). The default is 3 (.375 mm).
When using PC Line-Draw characters,
specify 0.
Example: ESC-a2
Sets the space between text lines to .25 mm.
ESC-'J'-
Performs a specified number of .125mm line
feeds.
The number of line feeds, specified in
hex. The default is 1 (.125 mm).
Using Flash Memory Graphics
You can also use a graphic previously stored in flash memory. You are
limited to one graphic stored in memory at a time. Saving a graphic to flash
memory when there is already one there overwrites the previous one.
1.
Remove the printer’s battery and wait several seconds.
2.
Re-insert the battery and enter Download Mode immediately (see
below). It takes two commands to make the transition to Download
Mode:
A.
ESC-'DL'
B.
ESC-'LG0'
Have the host wait to send the second command until the printer
responds to the first command by returning a ‘?‘ character.
3.
Transmit the graphic one line at a time using the ESC-V command as
described in “Using Data Stream Graphics.”
ESC-'V'-