Panasonic DMR-ES20 EN - Manual (Page 9)

RQT8212
9
G
e
tti
n
g
st
art
e
d
EN
GL
IS
H
•
Decoder here means the device used to decode scrambled broadcasts (Pay TV).
•
Change the “AV2 Input” and “AV2 Connection” settings in the SETUP menu to match the connected equipment ( ➔ page 35).
■ To enjoy multi-channel surround sound on
DVD-Video
Connect an amplifier with Dolby Digital, DTS and MPEG decoders
using an optical digital audio cable and change the settings in
“Digital Audio Output” (
➔ page 35).
•
You cannot use DTS Digital Surround decoders not suited to DVD.
•
Even if using this connection, output will be only 2 channels when
playing DVD-Audio.
■ Connection to a stereo amplifier
Connecting a digital/satellite receiver or decoder
Connecting an amplifier or system component
AV OUT
This unit’s rear panel
21-pin Scart cable
Digital/satellite receiver or
decoder’s rear panel Viewing video from the decoder on the television while
the unit is stopped, or while recording
If you connected the television to the AV1 terminal and the
decoder to the AV2 terminal on this unit, press
[0]+[ENTER]. (“DVD” appears on the unit’s display.)
Press again to cancel. (“TV” appears on the unit’s display.)
•
If the television is compatible with RGB input, the RGB
output signal from the decoder can also be output from
the main unit the same way.
OPTICAL IN
Optical digital audio cable
Do not bend this cable sharply.
Insert fully, with this side facing up.
This unit’s rear panel
Amplifier’s rear panel
AUDIO IN
R L
Amplifier’s rear panel
This unit’s rear panel
Audio cable
Red White
White
Red
Do not place the unit on
amplifiers or equipment
that may become hot.
The heat can damage the unit.
Note to owners of progressive compatible PAL system televisions
•
If you have an LCD/plasma television or LCD projector
Using progressive output, you can enjoy high-resolution video
recorded on media such as DVD-Video. Connect this unit’s
component video output terminals to your television and turn on the
progressive output setting (
➔ page 12).
•
If you have a CRT (cathode ray tube) television
Use component output with progressive “Off” (Factory setting,
➔ page 35), even if it is progressive compatible, because
progressive output can cause some flickering. This is the same for
multi system televisions using PAL mode.
COMPONENT
VIDEO OUT
COMPONENT
VIDEO IN This unit
Progressive output
COMPONENT
VIDEO OUT
COMPONENT
VIDEO IN This unit
Progressive output