Pentax Optio E50 - Manual (Page 62)

60
4
Tak
ing Pi
cture
s
5
Pan the camera to the right and
take the second frame.
Be sure to make the “overlay” cover the
same position in the second frame when
you compose.
Pan the camera to the right and press the
shutter release button fully to take the
second frame. After the Instant Review of the second frame, the
camera is ready for taking the third frame.
Repeat Steps 4 and 5 to take the third frame. After the third frame is
taken, the message “Data being processed” will blink. After the Instant
Review of the full panoramic picture, the camera will return to the
screen to take the first frame again.
To stitch only the first frame and the second frame into a panoramic
picture, go to Step 6 and select “Save” in Step 7.
6
Press the 4 button.
A confirmation screen for saving the taken
image(s) appears.
7
Use the four-way controller (23)
to select “Save”, “Discard”, or
“Cancel” and press the 4
button.
“Save” : When you select “Save” after the first frame is taken, the
frame taken is saved, and the camera will return to the
screen to take the first frame.
When you select “Save” after the second frame is taken,
the message “Data being processed” blinks, and after the
Instant Review of the 2 frames stitched together, the
camera will return to the screen to take the first frame.
“Discard” : All the frames taken will be discarded, and the camera will
return to the screen to take the first frame.
“Cancel” : The camera quits the operation and returns to the most
recent shooting screen.
To quit taking panoramic pictures
In mode, the flash does not discharge.
2nd frame 2nd frame SHUTTER
1 2
Exit Exit OK
Save
Save the image(s) and
exit this screen?
Save the image(s) and
exit this screen?
Discard
Cancel
MENU OK OK OK OK