Power save mode, Wide mode – Panasonic AG-DV2000P User Manual
Page 20
Power Save Mode
1
Press MENU, and then select OPTION SETUP1.
On Screen Display
Wide Mode
1
Press MENU, and then select OPTION SETUP1.
2 Select WIDE MODE.
2
Select POWER SAVE MODE.
3
Select OFF or S1.
3
Select OFF, 2H or 6H.
OFF:
When the S-Video input socket on the monitor
that is connected is an S-Video socket.
S1:
When the S-Video input socket on the monitor
OFF:
This setting does not conserve power when the
that is connected is an S1 -Video socket.
VCR is off.
(If a wide mode video signal is sent to the
2H:
The VCR turns off automatically if no operation is
monitor, the monitor screen size will automatically
performed for approximately two hours.
switch to wide mode.)
6H:
The VCR turns off automatically if no operation is
performed for approximately six hours.
4
Press MENU twice to exit the On Screen Display.
4
Press MENU twice to exit the On Screen Display.
To Set the Remote mode
1
Press MENU, and then select OPTION SETUP1.
2 Select REMOTE MODE.
3
Select VCR1, VCR2 or VCR3.
This allows the remote controller to be set for operating
VCR1, VCR2 or VCRS.
When changing the remote control mode, press
VCR1 ,VCR2 or VCR3 while holding down POWER
to change the remote control mode of the remote
controller. If this is not done, it will not be possible to
operate the VCR using the remote controller.
4
Press MENU twice to exit the On Screen Display.
20