Philips AXIS 5900 - Manual (Page 49)

Adding Printers in NetWare
AXIS 5900 User’s Manual 49
Section 6 Adding Printers in NetWare
This section describes how to continue the installation of the AXIS 5900
in the NetWare environment. Identify which transport protocol you are
running on your network and which installation method you should use.
Continue the installation by selecting the appropriate installing
instructions from the table below:
See “NetWare Administration” on page 75 for information on Novell’s
administration tools.
If you intend to operate your AXIS 5900 in a multi-protocol, mixed
environment, you should also proceed to the other relevant sections in
this manual.
Installation
method Transport
protocol
Action
NDPS
TCP/IP
IPX/SPX
See “Setup using NDPS” on page 50 and
“Public Access Printers” on page 51
“Controlled Access Printers” on page 54
iPrint
iPrint over LPR
See “Setup using iPrint” on page 66 and
“Install a Printer using AXIS LPR Gateway Configuration Snap-in”
on page 68
iPrint over IPP
See “Setup using iPrint” on page 66 and
“Install a Printer with AXIS IPP Gateway Configuration Snap-in”
on page 67
Queue-based
printing
IPX/SPX
Basic
Configuration
To install using the AXIS NetPilot Installation Wizard,
see “Basic Setup with AXIS NetPilot” on page 70
IPX/SPX
Advanced
configuration If you need a more advanced installation that is not covered by
the AXIS NetPilot Installation Wizard, see
“Advanced Installation using AXIS NetPilot” on page 71