Precor Low-Impact Threadmill M9.57 - Manual (Page 68)

Owner’s Manual: Advanced Programming and Troubleshooting 66
Troubleshooting Error Codes
If any error codes appear in the center display, turn the
unit Off and On. If the error continues to occur, call
an authorized service person for assistance. Refer to
Obtaining Service.
Troubleshooting Heart Rate
Table 9 may help you understand and troubleshoot erratic
heart rate readings.
Important: A heart rate can only be detected when the
Precor heart rate receiver is properly installed in the display
and the treadmill is turned On. You must also wear the chest
strap or hold on to both touch-sensitive handrail grips.
To conduct electrical impulses from a user’s heart, both
touch-sensitive handrail grips must be grasped firmly
for five to ten seconds. Usually, the concentration of salts
in a person’s perspiration provides enough conductivity to
transmit a signal to the receiver in the display console.
However, because of body chemistry or erratic heartbeats,
some people cannot use the heart rate feature. A chest strap
may provide better results. Refer to the QuickStart Card for
proper placement of the chest strap.
Table 9. Erratic heart rate readings
What appears on
the display
Cause What to Do
Nothing The heart rate
receiver is not
installed or it
has been
disconnected. To receive Customer
Support, refer to
Obtaining Service.
Hr A signal is being
detected, but the
transmission
requires more
time to establish a
heart rate. Be sure the chest strap
is in direct contact with
your skin. If using the
touch-sensitive handrail
grips, use both hands and
make sure your hands are
moist, not dry.
Pulsing HEART The LED heart
blinks when a heart
beat is detected. If the LED is pulsating,
it indicates that the
heart rate equipment is
working properly.