Precor Low-Impact Threadmill M9.57 - Manual (Page 60)

Owner’s Manual: Exercise Session 58
Changing Safety Code Protection
You can change the safety code setting while exercising, by
taking the following steps:
1. Press the OPTIONS key until SAFETY CODE appears.
2. Press OK.
3. The current setting appears in the display. Use the
navigational arrow keys to toggle between the two
options.
CAUTION: Precor recommends that you leave the
safety code ENABLED. If you choose to change the
security of the treadmill, it is your responsibility to
make sure that no children or persons unfamiliar with
its operation are allowed on or near the treadmill. Do
not assume the unit is safe because of safety code
protection.
4. When you are ready, press OK to accept the displayed
setting. A message scrolls across the display indicating
the condition of safety code protection as you continue
your exercise session.
Setting Description
ENABLED Causes the safety code prompt to
appear prior to a workout and when
returning from pause mode.
DISABLED Does not require a safety code to
operate.
OPTIONS