How to clear a programmed recording (timer), Nextview link – Philips VR700/58 User Manual

Page 23

D While a programmed recording is being made, you

cannot operate your video recorder manually. If you
want to cancel the programmed recording, press the

STANDBY m

button.

D If the video recorder is switched on a few minutes

before a programmed recording is supposed to
begin, ’SWITCH TO STANDBY - TIMER
RECORDING’ will flash on the TV screen.

D If you reach the end of the cassette during a

recording, the video recorder will automatically
eject the cassette.

D If you forget to load a cassette, ’NO CASSETTE’

will appear on the TV screen and ’

’ will flash on the

video recorder display.

D If you have put in a cassette which cannot be used

for recording, the video recorder will automatically
eject it.

D If `TIMER FULL´ appears on the TV screen when

you press the

TIMER k

button, you have used up all

the available TIMER blocks. If you want to clear or
check a programmed recording (TIMER block),
press the

button and select the TIMERR block

with the

P ;

P =

button.

D Programme numbers ’E1’ and ’E2’ are for

recordings from other sources (through scart socket

EXT.1 AV 1

EXT.2 AV 2

How to check or change a programmed
recording (TIMER)

Switch on the TV set and select the programme number
for the video recorder.

Press the

TIMER k

button on the remote control.

The programming mode selected last is marked.

Select the line ’TIMER LIST’ with the

P =

P ;

button and confirm with the

button.

Select the programmed recording (TIMER) you want to
check or change with the

P ;

P =

button.

Press the

button.

Select the entry field with the

button.

Change any information with the

P =

P ;

button or

with the

0-9

buttons.

D Under ’END’, use the

SELECT.

button to select the

recording speed ’SP’ or ’LP’.

Confirm with the

button.

To end, press the

TIMER k

button.

Make sure that the cassette you have put in can be
recorded on. Switch off with the

STANDBY m

button.

D The programmed recording will only function when

the video recorder is switched off with the

STANDBY m

button.

How to clear a programmed recording
(TIMER)

Switch on the TV set and select the programme number
for the video recorder.

Press the

TIMER k

button on the remote control.

The programming mode selected last is marked.

Select the line ’TIMER LIST’ with the

P =

P ;

button and confirm with the

button.

Select the programmed recording (TIMER) you want to
clear with the

P =

P ;

button.

Press the

CLEAR (CL)

button.

Confirm with the

button.

Switch off with the

TIMER k

button.

’NexTView Link’

This video recorder is equipped with the function ’NexTView
Link’. If your television is also equiped with this function, you
can mark TV programmes on the television for programming.
These TV programmes will automatically be transmitted to a
TIMER block on the video recorder. If you clear the marking of
the TV programme on the television, the corresponding TIMER
block on the video recorder will also be cleared.
For more information, read the instruction manual of your TV
set.