Philips VR700/58 - Manual (Page 22)

D Use the
SELECT. button to switch ’VPS/PDC’ on or
off in ’START’.
D Use the
SELECT. button to select the recording
speed ’SP’ or ’LP’ in ’END’.
g Confirm with the OK button when the information is
correct.
D The programming information has been stored in a
TIMER block.
h To end, press the TIMER k button.
i Make sure that the cassette you have put in can be
recorded on.
j Switch off with the STANDBY m button.
The programmed recording will only function when the
video recorder is switched off with the
STANDBY m
button.
D If any of the TIMER blocks are in use, ’
k ’ will light up
on the video recorder display.
D While a programmed recording is being made, you
cannot operate your video recorder manually. If you
want to cancel the programmed recording, press the
STANDBY m button.
D If the video recorder is switched on a few minutes
before a programmed recording is supposed to
begin, ’SWITCH TO STANDBY - TIMER
RECORDING’ will flash on the TV screen.
D If you reach the end of the cassette during a
recording, the video recorder will automatically
eject the cassette.
D If you forget to load a cassette, ’NO CASSETTE’
will appear on the TV screen and ’ k ’ will flash on the
video recorder display.
D If you have put in a cassette which cannot be used
for recording, the video recorder will automatically
eject it.
D If ’TIMER FULL’ appears on the TV screen when
you press the TIMER k button, you have used up all
the available TIMER blocks. If you want to clear or
check a TIMER block, select it with the
P ; or
P = button.
D Programme number ’AUX’ is provided for audio
recordings via sockets AUX IN L R .
Programming a recording
(without ’SHOWVIEW’)
a Switch on the TV set and select the programme number
for the video recorder.
b Press the TIMER k button on the remote control.
The programming mode selected last is marked.
c Select the line ’TIMER PROGRAMMING’ with the
P = or P ; button and confirm with the P button.
TIMER
TIMER PROGRAMMING
VPS
DATE PROG. START PDC END LP
01 BBC1 20:00 21:30
________________________________
TO STORE MO-FR/WEEKLY
PRESS
SELECT PRESS OK
d Select the entry field with the Q or P button.
e Enter information with the P = or P ; button or with
the digit buttons 0-9 .
D Under ’DATE’, use the
SELECT. button to select
daily or weekly programming.
’MO-FR’: Recording from Monday to Friday.
’MO’: Recordings every week on the same day.
D Under ’START’, use the
SELECT. button to switch
’VPS or PDC’ on or off.
D Under ’END’, use the
SELECT. button to select the
recording speed ’SP’ or ’LP’.
f Confirm with the OK button when the information is
correct.
D The programming information has been stored in a
TIMER block.
g To end, press the TIMER k button.
h Make sure that the cassette you have put in can be
recorded on.
i Switch off with the STANDBY m button.
The programmed recording will only function when the
video recorder is switched off with the
STANDBY m
button.
D If any of the TIMER blocks are in use, ’
k ’ will light up
on the video recorder display.
20