Philips VR700/58 - Manual (Page 11)

Satellite receiver
You can receive channels from the satellite receiver via the
scart socket
EXT.2 AV 2 .
To do this, select the channel number ’E2’ by pressing the
buttons
P ; or P = . You will have to select the channels to
be received by the satellite receiver on the receiver itself.
Special installation functions
You can select one of the following installation functions in
order to adapt the video recorder to your own specific
requirements.
Automatic TV Channel Allocation (FOLLOW
TV)
With this function the video recorder maintains the same
channel sequence as on the TV set, in case you connected
your videorecorder to a TV set without scart cable. This only
functions if the video recorder (socket
EXT.1 AV 1 ) and the TV
set are connected with a scart cable.
D Additional equipment connected to socket
EXT.2 AV 2 must be switched off.
D With ’Connecting with scart cable and ’Easy
Link/NexTView’, this function will start the data
transfer.
a Switch on the TV set. If required, select the programme
number for the video recorder.
b Press the MENU button. The main menu appears.
c Select the line ’INSTALLATION’ with the P = or
P ; button and confirm with the P button.
MAIN MENU
INSTALLATION
AUTOM. SEARCH
FOLLOW TV
MANUAL SEARCH
TV CHANNEL ALLOCATION
OPTIMIZE MODULATOR
TIME/DATE
LANGUAGE
COUNTRY
TO EXIT
PRESS
MENU
d Select the line ’FOLLOW TV’ with the P = or P ;
button and confirm with the P button. Take notice of
the message on the TV screen.
e Press the OK button. ’TV01’ appears in the video
recorder display.
TV01
f Select programme number ’1’ on the TV set.
g Confirm with the OK button on the video
recorder-remote control. The video recorder compares
the TV channels on the TV set and the video recorder.
If the video recorder found the same TV channel as the
TV set, then it stores it at ’P01’.
D When ’NOTV’ (no signal from TV set) appears in the
display, the TV channels can not be allocated
automatically. In this case, read paragraph: ’Manual
TV channel allocation’.
h Wait until e.g.: ’TV02’ appears.
i Select the next programme number, e.g.: ’2’ on the TV set.
j Confirm with the OK button on the video
recorder-remote control.
D If you have allocated the wrong TV channeL, you
can go back one step with the Q button.
k Repeat steps h to j until all TV channels have been
allocated.
l To end, press the MENU button.
9