beautypg.com

Safety when working with electricity, Preventing electrostatic discharge damage – Patton electronic RocketLink 3202 User Manual

Page 14

background image

14

Model 3202 Getting Started Guide

About this guide

Safety when working with electricity

Preventing Electrostatic Discharge Damage

When starting to install interface cards place the interface card on its shielded plastic bag if you lay it on
your bench.

Electrostatic Discharge (ESD) can damage equipment and impair electrical circuitry. It occurs when electronic

The Model 3202 contains no user serviceable parts. The equipment shall be
returned to Patton Electronics for repairs, or repaired by qualified service per-
sonnel. Opening the Model 3202 case will void the warranty.

Mains Voltage: Do not open the case the when the power cord is attached.
Line voltages are present within the power supply when the power cords are
connected. The mains outlet that is utilized to power the device shall be within
10 feet (3 meters) of the device, shall be easily accessible, and protected by a
circuit breaker.

For AC powered units, ensure that the power cable used meets all applicable
standards for the country in which it is to be installed, and that it is connected
to a wall outlet which has earth ground.

Hazardous network voltages are present in WAN ports regardless of whether
power to the Model 3202 is ON or OFF. To avoid electric shock, use caution
when near WAN ports. When detaching the cables, detach the end away from
the Model 3202 first.

Do not work on the system or connect or disconnect cables during periods of
lightning activity.

In accordance with the requirements of council directive 2002/
96/EC on Waste of Electrical and Electronic Equipment (WEEE),
ensure that at end-of-life you separate this product from other
waste and scrap and deliver to the WEEE collection system in
your country for recycling.

WARNING

WARNING

WARNING

WARNING

WARNING