Polaris 500 2X4 - Manual (Page 69)

66
MAINTENANCE AND LUBRICATION
Engine Oil
Oil and Filter Change (TM)
1. Position the vehicle on a level surface.
2. Run the engine two to three minutes until
warm, then stop the engine.
3. Clean the area around the drain plug (6) at the bottom of the
engine. The plug is accessible through the access hole in the
bottom of the skid plate.
CAUTION
Hot oil can cause serious burns. Do not allow hot oil to come into
contact with skin.
4. Place a drain pan beneath the engine and remove the drain plug.
Allow the oil to drain completely.
5. Replace the sealing washer on the drain plug.
NOTE: The sealing surfaces on the drain plug and crankcase should
be clean and free of burrs, nicks or scratches.
6. Reinstall the drain plug and torque to 14 ft. lbs. (19 Nm).