Paradyne 3162 - Manual (Page 9)

7
Table 3. Synchronous Data Port Configuration Options (1 of 2)
Option Factory 1 Factory 2 Comments/Description
E530 E530
Port Type:
V.35 V.35
Selects the port type: EIA-530A,
Port Type:
RS449 RS449
Selects the port type: EIA-530A,
V.35, RS449, or X.21.
X.21 X.21
Port Base Rate:
Nx64 Nx64
Enables the port to either Nx56 or
Port Base Rate:
Nx56 Nx56
Enables the port to either Nx56 or
Nx64 rates.
Transmit Clock
Internal Internal Selects whether the transmitted
data clock is internal (TXC) or
Transmit Clock
Source:
External External
data clock is internal (TXC) or
external (XTXC).
Embedded Data
Enable Enable
Specifies whether the Embedded Embedded Data
Link:
Disable Disable
Specifies whether the Embedded
Data Link is enabled.
EDL Management
Disable Disable
Specifies whether the EDL EDL Management
Link:
Enable Enable
Specifies whether the EDL
Management Link is Enabled.
Invert Transmit
Clock: Enable Enable
Selects phase inversion of the
Clock:
Disable Disable
Selects phase inversion of the
transmit clock (TXC).
Invert Transmit and
Enable Enable
Allows the data on the port to be Invert Transmit and
Received Data:
Disable Disable
Allows the data on the port to be
inverted.
Disable Disable
Send All Ones on
Data Port Not DTR DTR
All ones sent to network (DTE) T1
Data Port Not
Ready:
RTS RTS
All ones sent to network (DTE) T1
when DTR or RTS interrupted.
eady
Both Both
Action on Network
Yellow Alarm: None None Data port remains enabled, or is
disabled on receiving Yellow on
Yellow Alarm:
Halt Halt
p ,
disabled, on receiving Yellow on
network T1.
Disable Disable
Network Init. Data
V.54 V.54 Network-initiated DCLB, allows
DCLB t b
t ll d b i b d
Network Init. Data
Channel Loopback:
FT1 FT1
Network initiated DCLB, allows
DCLB to be controlled by inband
V.54 or FT1 (ANSI) codes.
Both Both
5 o ( S ) codes