Panasonic KX-FPG391 - Manual (Page 81)

8. Programmable Features
79
“ STANDARD” (default): Recording sound quality
is standard, and the maximum recording time is
approximately 15 minutes.
“
ENHANCED”: Recording sound quality is
clearer, and the maximum recording time is
approximately 7 minutes.
Code #54: Changing the recording time for
your TAM/FAX greeting message
GREETING TIME
MODE=16s [ ±]
“ 16s” (default): Maximum recording time is 16
seconds.
“
60s”: Maximum recording time is 60 seconds.
See page 66 for details.
Code #59: Copying phone book data from the
base unit to a handset
COPY PHONE BOOK
=1 ITEM [ ±]
See page 42 for details.
Code #62: Setting line mode
SET LINE MODE
MODE=B [ ±]
The default setting of the line mode is “ B”.
Generally leave this setting to “ B”. If a change of
the line mode setting is required by our customer
call center or service personnel, change the line
mode to “
A”.
Note:
L You can also program this feature with the
handset (page 87).
Code #67: Setting the incoming message
monitor
ICM MONITOR
MODE=ON [ ±]
To hear an incoming message (ICM) from the
speaker when the answering machine is
recording the message.
“
ON” (default): You can monitor the incoming
message.
“
OFF”: Deactivates this feature.
Code #72: Setting flash time
SET FLASH TIME
MODE=700ms [ ±]
The flash time depends on your telephone
exchange or host PBX.
You can select “
90ms” (milliseconds), “100ms”,
“ 110ms”, “250ms”, “300ms”, “400ms”,
“ 600ms” or “700ms” (default).
Note:
L If the unit is connected via a PBX, PBX
functions (transferring a call etc.) might not
work correctly. Consult your PBX supplier for
the correct setting.
L You can also program this feature with the
handset (page 86).
Code #73: Setting incoming call tone
INCOMING CALL
TONE=2 [ ±]
During an intercom call (page 49) or while using
the room monitor feature (page 52), you can be
informed by 2 tones if a call arrives.
“
2” (default): The incoming call tone will sound 2
times.
“
ON”: The incoming call tone will be heard for as
long as the line rings.
“
OFF”: Deactivates this feature.
Note:
L You can also program this feature with the
handset (page 84).
L To set the handset incoming call tone, see
page 84.
Code #74: Setting room monitor
ROOM MONITOR
MODE=OFF [ ±]
See page 52 for details.
Code #75: Setting the Caller ID number auto
edit feature
CALLER ID EDIT
MODE=ON [ ±]
See page 46 for details.
Code #76: Setting the connecting tone
CONNECTING TONE
MODE=ON [ ±]
If you often have trouble when sending faxes,
this feature allows you to hear connecting tones:
fax tone, ring back tone and busy tone. You can
use those tones to confirm the status of the other
party’s machine.
“
ON” (default): You will hear connecting tones.
“ OFF”: Deactivates this feature.
Note:
L If the ring back tone continues, the other
party’s machine may not be a fax machine or
may have run out of paper. Check with the
other party.
L The connecting tone volume cannot be
adjusted.
FPG391_en.book Page 79 Friday, July 16, 2004 5:38 PM