PYLE Audio DVDR5520H - Manual (Page 22)

English
22
MAINS
HDMI
OUT
S-VIDEO
OUT
AUDIO
OUT
COAXIAL
DIGITAL OUT
COMPONENT
VIDEO OUT
COAXIAL
DIGITAL
IN
CVBS-OUT P B
P R
Y
R
L TO VCR/SAT EXT 2 TO TV EXT 1
ANALOG
ANTENNA INPUT TO TV ANTENNA
INPUT
DIGITAL
ANTENNA INPUT
DIGITAL ANTENNA
LOOP THROUGH ANTENNA INTERCONNECT CABLE
(OPTIONAL, REFER TO MANUAL)
G-LINK
TV
VHF/UHF
RF IN
VHF/UHF
RF OUT
SCART OUT SCART IN
B
C
D
Step 2: Optional Connections
(continued)
VCR (example only)
Connecting to a VCR or
other similar device
This connection enables you to record
from video tape to hard disk and allows
the VCR to be used for playback on the
TV if the recorder is turned off.
Note:
Your new recorder can replace the VCR
for all your recording needs. Just unplug
all the connections to your VCR.
A Connect the antenna cables. See
‘Connecting the antenna cables’ in Step 1:
Basic Connections chapter for more
information.
B Connect a RF antenna cable (supplied)
from the TO TV ANTENNA INPUT
socket on the recorder to the
antenna input socket on your TV (usually
labelled as ANT, ANTENNA IN, RF IN).
C Connect a scart cable (supplied) from the
EXT1-TO TV socket on the recorder
to the corresponding SCART socket on
the TV.
D Connect another scart cable (not
supplied) from the EXT2-TO VCR/
SAT socket on the recorder to the Scart
socket (usually labelled as TV OUT or
TO TV) on the VCR.
Helpful Hints:
– Most commercial video cassettes and
DVDs are copy-protected and therefore
cannot be recorded.
– Connect the recorder directly to the TV. If
there is a VCR or an additional device in
between, the picture quality may be poor.