Panasonic KX-FC962HK - Manual (Page 33)

4. Telephone
33
4.7.1 Cordless handset:
Setting night mode ON/OFF
1. Press {j/OK}.
2. Select “ Handset Setup”, then press {>}.
3. Select “ Ringer Setup”, then press {>}.
4. Select “ Night Mode”, then press {>}.
5. Select “ On/Off”, then press {>}.
6. Select “ On” or “Off” (default), then press
{>} .
7. Press {ih}.
Note:
L When the night mode is turned ON, “ [N]” is
displayed.
Setting the start and end time for night
mode
1. Press {j/OK}.
2. Select “ Handset Setup”, then press {>}.
3. Select “ Ringer Setup”, then press {>}.
4. Select “ Night Mode”, then press {>}.
5. Select “ Start/End”, then press {>}.
6. Enter the desired hour and minute you wish
to start this feature by selecting 2 digits for
each.
L If you use 12-hour time entry, select “ AM”
or “ PM” by pressing {*} repeatedly
before entering the time.
7. Enter the desired hour and minute you wish
to end this feature by selecting 2 digits for
each.
L If you use 12-hour time entry, select “ AM”
or “ PM” by pressing {*} repeatedly
before entering the time.
8. Press {j/OK}.
9. Press {ih}.
Setting the ring delay for night mode
This setting allows the cordless handset to ring
during night mode if the caller waits long enough.
After the selected delay time has passed, the
cordless handset will ring. If you select “
No
Ringing”, the cordless handset will not ring
during night mode.
1. Press {j/OK}.
2. Select “ Handset Setup”, then press {>}.
3. Select “ Ringer Setup”, then press {>}.
4. Select “ Night Mode”, then press {>}.
5. Select “ Ring Delay”, then press {>}.
6. Select “ 30 sec.” or “60 sec.”, then press
{>} .
7. Press {ih}.
Selecting categories to bypass night mode
1. Press {j/OK}.
2. Select “ Handset Setup”, then press {>}.
3. Select “ Ringer Setup”, then press {>}.
4. Select “ Night Mode”, then press {>}.
5. Select “ Select Category”, then press
{>} .
6. Press the desired category numbers, then
press {j/OK}.
L The selected category number will flash.
L To cancel a selected category number,
press the number again. The number will
stop flashing.
7. Press {ih}.
4.7.2 Base unit:
Setting night mode ON/OFF
1. Press {MENU}.
2. Press {#}, then {3}{5}.
3. Press {SET}.
4. Press {A} or {B} repeatedly to select
“ ON/OFF”, then press {SET}.
{ih}
{j /OK}
{>}
{A}{B}
{ SET}
{ MENU}
FC962HK-PFQX2283ZA-en.book Page 33 Thursday, September 15, 2005 4:20 PM