Panasonic DIGA DMR-EZ27 - Manual (Page 61)

61
RQT8851
Ref
erence
Main Unit
REC
The unit’s display Disc tray
Remote control
signal sensor
1
2 4 3 5 6 78 9 bk
Opening the front panel
Press down on the part
with your finger.
1 POWER on/off button (POWER ^/I) ........... ( ➔ 6)
Press to switch the unit from on to standby mode or vice versa.
In the standby mode, the unit is still consuming a small amount
of power.
2 Connector for a digital video (DV)
camcorder ................................................. ( ➔ 25)
3 SD card slot .............................................. ( ➔ 64)
4 IN2 input terminals (IN2) .......................... ( ➔ 24)
•
5 Channel Select ........................................... ( ➔ 6)
6 Stop button ................................................. ( ➔ 7)
7 Play/x1.3 button .......................................... ( ➔ 7)
8 Reset button ............................................. ( ➔ 66)
9 Start recording ............................................ ( ➔ 8)
bk Disc tray open/close button ........................ ( ➔ 7)
The Unit’s Display
1 2
3 4 5
1 Recording indicator
2 Main display section
3 Disc indicator
This indicator lights up when a disc that is supported by this
unit is inserted.
4 Scheduled recording indicator ( ➔ 9)
On:
When a scheduled recording program is registered and a
recordable disc is inserted.
Flashes:
The scheduled recording indicator flashes when the unit cannot
go to scheduled recording standby (e.g. there is no disc, etc).
It does not flash if Quick Start is off.
5 Progressive indicator
This indicator lights up when you select “On” in “Progressive”
(
➔ 37).